Remote Shack with Expert Remote 

'all-in-one-place' practical setup guide
  • SunSDR 2/Pro/DX/MB1 minimal settings.
    The only configuration to confirm with SDR is its IP address set to factory default 192.168.16.200

    When ready, connect SDR with Ethernet cable into port ETH2 Mini-PC and power up the device.

  • Final checks and measurements
    Once SDR powered, you should see it in Raspberry PI's browser connected to localhost:5531:

    Now it is time to add SDR to Location in Expert Cloud:

    and test with ESDR2 - ether via own account or shared link.

    For those interested to understand what real load the opnSense Gateway/FW registers, when remote connection is online, here are the details for model N5105 Intel(R) Celeron(R) N5105 @ 2.00GHz (4 cores) 8GB RAM 128GB SSD:
    CPU average on 10% with short spikes up to 42% (less than a second, no more than 2 spikes in a minute)
    Memory on average 4.1%
    Disk utilisation less than 1%
    Inbound Traffic: max 5Mbps
    Outbound Traffic: max 4Mbps
    • BACK     NEXT